Machined and welded parts for industrial and special machinery

Plates, housings, frames and welded bases for machine builders, from a single part to small series, often with drawing revisions between batches. Made in our audited network in Bursa, to your drawing.

Email a drawing
L-shaped milled aluminium bracket with a large bore and countersunk mounting holes
IndustryIndustrial & special machinery
Typical partsPlates, housings, machine frames, welded bases
MaterialsS235 / S355, C45, Al 6082, 1.4301
Batch sizeSingle part to small series
Contactsales@ertas.engineering

Parts we quote for machine builders

Typical parts and what the drawing usually asks for. Your drawing decides; this is where we usually start.

PartTypical materialProcessWhat the drawing usually asks for
Mounting and base platesS355, Al 6082CNC millingFlat mounting faces, hole patterns to the drawing, general tolerances to ISO 2768-m
Housings and bearing blocksC45, Al 6082CNC milling, CNC turningBore fits, positional tolerances between bores, thread depths
Shafts, pins and bushesC45, 1.4301CNC turningDiameter fits, surface finish on running faces
Machine frames and welded basesS235 / S355Welded assemblies, CNC millingWeld quality level, machining after welding on mounting faces
Guards and coversSteel sheet, 1.4301Sheet metalBend dimensions, burr-free edges, coating to your specification
Small sub-assembliesMixed, per drawingAssembly & finishingFit check against the drawing, parts list complete

Materials: structural steel S235 / S355, C45, EN AW-6082, stainless 1.4301.

What we check before parts leave

The points machine-building drawings usually call out, checked against your drawing.

  1. Drawing revisionEach batch is checked against the revision on your order, so a change between batches reaches the part.
  2. Fits and positionsBores, fits and hole positions measured on the features you mark as critical.
  3. Flatness after weldingMounting faces on welded bases machined after welding and checked for flatness.
  4. Weld qualityWelds inspected visually against the quality level on your drawing.
  5. Material on paperMaterial documented to EN 10204 3.1 and matched to the grade on your drawing.
  6. Critical dimensionsA measurement report for the features you mark, delivered with the parts.

Guides

Short references we use ourselves when reviewing a drawing.

Machined and welded parts for special machine buildersGuide
Welded assemblies: ISO 5817, ISO 3834 and EN 1090Guide
Quality documents for machined parts: 3.1, FAI, PPAP, CoCGuide

Other industries

Same network, same documents, different drawings.

Automotive & commercial vehiclesLow- and mid-volume parts, fixtures and gaugesAgricultural & construction machineryWelded frames, brackets, pins, hydraulic blocksEnergy & electrical equipmentCopper busbars, enclosures, machined bracketsHydraulics & fluid powerManifolds, valve blocks, turned partsPhotonics & lasersHousings, mounts, baseplates, cooling platesRobotics & automationJoint housings, grippers, frames in small seriesVacuum & semiconductor equipmentChambers, flanges, fixtures (non-litho)Research, cryogenics & quantumCryostat and beamline partsTest, measurement & labInstrument frames and precision partsData-center cooling & powerWelded manifolds, frames, enclosures

Send the drawing

Attach the drawing with its revision and the quantity. You get a route, a price and a lead time back.

SupplierErtaş Engineering
IndustryIndustrial & special machinery
SendDrawing with revision, quantity
Contactsales@ertas.engineering